SW20 Door Panel Patch
Made from a sheet of aluminum and some #6 bolts with fender washers/nuts on the backside. Epoxy was applied over the nuts on the back to hold them in place, because I didn't want to get them too tight.
![](images/92_mr2/door_panel_patch/aluminum_square.jpg)
![](images/92_mr2/door_panel_patch/bend1.jpg)
![](images/92_mr2/door_panel_patch/bend2.jpg)
![](images/92_mr2/door_panel_patch/hole_above.jpg)
![](images/92_mr2/door_panel_patch/hole_below1.jpg)
![](images/92_mr2/door_panel_patch/hole_below2.jpg)
![](images/92_mr2/door_panel_patch/on_panel_before_drilling.jpg)
![](images/92_mr2/door_panel_patch/patch_installed1.jpg)
![](images/92_mr2/door_panel_patch/patch_installed2.jpg)
![](images/92_mr2/door_panel_patch/patch_installed3.jpg)
![](images/92_mr2/door_panel_patch/patch_installed4.jpg)
![](images/92_mr2/door_panel_patch/patch_installed5.jpg)
Made from a sheet of aluminum and some #6 bolts with fender washers/nuts on the backside. Epoxy was applied over the nuts on the back to hold them in place, because I didn't want to get them too tight.